Insulating your garage door might not seem like a necessary task at all. In fact, to some, it might seem like a bit of a waste of time. But it would be a mistake to regard it as something that’s not needed as it can present you with some benefits.
You can’t argue with the fact that there are several benefits to insulating your garage door. First off, insulating your garage door will make it more energy-efficient and eventually help reduce your energy bills.
Another benefit is that it will strengthen your grand prairie tx garage door. It will be much stronger and more durable than it was before being insulated. It would be more resistant to damage, whether it’s from extreme weather or other causes. This makes it all the more important for you to know the proper steps to insulate your garage door.
What You’ll Need to Insulate Your Garage Door
To insulate your garage door properly, you’ll need the following materials:
- Tape measure
- Utility knife or box cutter
- Safety goggles
- Pen, pencil, or markers
- Work gloves
- Composite fasteners
- Garage door seal – optional
Steps to Follow to Insulate Your Garage Door
The following are the steps that need to be followed in order to insulate your garage door the right way:
- Make measurements. You need to measure so you can find the areas that are about 12 inches from each side. Mark those areas while making sure that they are properly centered.
- Cover the markings that you made. Use double-sided tape to cover all of the areas that you marked.
- Attach the retainer clips to the areas that you’ve covered with the tape.
- The next step is to measure the panels. Make sure that you’re able to measure each individual panel. Even though they will look like they are of the same size, they are probably not.
- Cut the insulation. Make sure that you cut the insulation for each panel. Each of the pieces needs to measure about 1 to 2 inches longer than each of the panels. You have to be sure that you’re wearing protective equipment such as gloves and goggles when you’re doing this part since insulation materials are usually irritating to the skin.
- Now you’ll have to tuck the insulation into each panel. Make sure that the shiny side is the one that’s facing forward. The covering should always be the part that’s visible.
- Fasten the clips. The retention clips are hidden underneath the insulation by now. You need to feel for them and make small incisions where they are and fasten them using the front side.
- Install a garage door seal. This would be the last of the steps to insulate your garage door properly. They’re used so that water wouldn’t leak beneath the door, reinforce the insulation, and also help keep pests out. Use adhesive and/or caulk to ensure that they’re secured to the ground.