Closing a Garage Door Repair Colleyville TX manually can seem like a daunting task, especially if you have never done it before. However, it is actually quite simple and can be done with just a few basic tools.

In this guide, we will explain step-by-step how to close a garage door manually.

Before we begin, it is important to note that manual garage door closing is not recommended unless there is a power outage or malfunction. It can be dangerous if not done correctly and can cause injury or damage to the door. It is always best to use the automatic opener if it is functioning properly.

Step 1: Release the Door from the Opener

Before you can close the door manually, you need to release it from the automatic opener. To do this, locate the release mechanism on the opener. It is usually a red handle or cord. Pull down on the handle or cord to disengage the door from the opener.

Step 2: Check the Door’s Balance

Before attempting to close the door manually, you should check to make sure that it is properly balanced. An unbalanced door can be difficult to lift or close manually and can be dangerous. To check the balance of the door, you can perform the following steps:

  1. Close the door using the automatic opener.
  2. Once the door is closed, pull the release mechanism to disengage the door from the opener.
  3. Lift the door halfway open and then let go.
  4. If the door stays in place, it is properly balanced. If it falls or rises, it is unbalanced and needs to be adjusted by a professional.

Step 3: Locate the Emergency Release Cord

Once you have released the door from the opener and checked its balance, you need to locate the emergency release cord. This cord is usually located near the center of the door, hanging down from the rail. It may be a red handle or cord. If you are unsure where it is located, refer to your owner’s manual.

Step 4: Pull the Emergency Release Cord

To close the door manually, you need to pull the emergency release cord down and toward the back of the garage. This will release the door from the trolley on the rail and allow you to manually lower it.

Step 5: Lower the Door Manually

With the door released from the trolley, you can now manually lower it to the ground. To do this, stand facing the door and grab the handle or the bottom of the door with both hands. Lift the door slightly to take the weight off the track and then lower it slowly and carefully.

It is important to keep your feet and hands away from the door as it is lowered to avoid injury. It is also important to keep the door straight as it is lowered to prevent it from binding or getting stuck.

Step 6: Secure the Door

Once the door is closed, you need to secure it in place. To do this, you can use the lock if your garage door has one. If not, you can use a clamp or locking pliers to secure the door in place. Simply clamp the pliers onto the track just above one of the rollers to prevent the door from being opened.

Step 7: Reconnect the Door to the Opener

When power is restored or the malfunction is resolved, you can reconnect the door to the opener. To do this, simply pull the emergency release cord toward the door and lift the door until it clicks into place on the trolley.

Step 8: Test the Door

Once the door is reconnected to the opener, you should test it to make sure that it is functioning properly. Use the remote or wall switch to open and close the door. If it is not working correctly, you may need to contact a professional for repairs.

In conclusion, manually closing a Garage Door Repair Colleyville TX can be done with just a few simple steps. It is important to follow these steps carefully to ensure your safety and the proper functioning of the door. Remember to only close the door manually if there is a power outage or malfunction and to always use caution when handling the door.

Colleyville Garage Door and Gates

Colleyville Doors and Gates
102 Williamsburg Ct Suit 1C
Colleyville, TX 76034

817-904-4816