Programming a Clicker keypad to a Craftsman  Garage Door Repair Volo IL allows you to operate your garage door using a secure entry code.

Here’s a step-by-step guide on how to program a Clicker keypad to a Craftsman garage door opener:

1. Prepare Your Keypad:

  • Ensure that the Clicker keypad’s battery is installed and functional. Remove the keypad cover to access the programming buttons if necessary.

2. Identify the “Learn” Button on the Craftsman Opener:

  • Locate the motor unit of your Craftsman garage door opener. On the motor unit, you’ll find a “Learn” button. This button is usually located near the antenna wire hanging from the unit. The button may be colored red, yellow, green, or purple, depending on the model.

3. Clear Existing Codes (Optional):

  • If you’re reprogramming your opener or adding a new keypad, it’s recommended to clear existing codes first. Press and hold the “Learn” button on the opener unit until the indicator light turns off, typically for about 6-10 seconds.

4. Enter Programming Mode on the Keypad:

  • On the Clicker keypad, press and hold the “Program” button until the LED light starts blinking. This indicates that the keypad is ready to receive programming.

5. Enter Your Desired PIN Code:

  • Using the keypad, enter your desired PIN code. The code can typically be 4-8 digits long, depending on the keypad model.

6. Press the “Learn” Button on the Opener:

  • Once you’ve entered the PIN code, press the “Learn” button on the Craftsman opener unit. The indicator light on the opener should illuminate, indicating that it’s ready to receive the programming signal.

7. Transmit the Programming Signal:

  • Within 30 seconds of pressing the “Learn” button on the opener, enter your PIN code on the Clicker keypad and press the “Enter” or “Send” button. This transmits the programming signal to the opener.

8. Test the Keypad:

  • After programming, test the Clicker keypad by entering your PIN code and pressing the “Enter” or “Send” button. The garage door should open or close accordingly.

9. Repeat if Necessary:

  • If you have multiple keypads to program or want to add additional PIN codes, repeat the above steps for each keypad.

10. Finalize Programming (Optional):

  • Some models may require additional steps to finalize programming or adjust settings. Consult your Craftsman opener’s user manual for specific instructions.

11. Troubleshooting:

  • If you encounter any issues during programming, such as the keypad not responding or the indicator light not illuminating, double-check the programming steps and ensure you’re within range of the opener unit.
  • If problems persist, refer to your Craftsman opener’s user manual or contact customer support for assistance.

Always refer to your opener’s user  Garage Door Repair Volo IL and troubleshooting tips.

EDM Garage Doors, LLC

596 Richard Brown Blvd, Volo, IL 60073, United States

1-847-416-3036