Resetting a Clicker garage door repair keypad can be a simple process if you follow the steps carefully. The Clicker garage door keypad is a popular accessory for garage doors that is used to provide a secure way to enter and exit the garage.
If you are experiencing issues with your Clicker garage door keypad, or if you simply want to reset it for any reason, you can follow the steps outlined below.
Before beginning the reset process, you will need to ensure that your Clicker garage door repair keypad is properly mounted and that the battery is not dead. You will also need to know the current code for the keypad. If you do not know the current code, you will not be able to reset the keypad.
Step 1: Locate the Learn Button
The first step in resetting your Clicker garage door keypad is to locate the Learn Button on your garage door opener. The Learn Button is usually located on the back of the motor unit, near the antenna wire. It may also be located on the side of the motor unit, depending on the make and model of your garage door opener.
Step 2: Press the Learn Button
Once you have located the Learn Button, press and hold it down for approximately 6 seconds. This will activate the programming mode for your garage door opener.
Step 3: Enter a New Code
With the garage door opener in programming mode, enter a new code on your Clicker garage door keypad. The code should be between 4 and 8 digits in length. Make sure that the code is easy for you to remember but difficult for others to guess.
Step 4: Press the Learn Button Again
After entering the new code on your Clicker garage door keypad, press and release the Learn Button on your garage door opener. This will save the new code and reset the keypad.
Step 5: Test the New Code
To ensure that the new code has been successfully programmed into your Clicker garage door keypad, test the code by pressing the new numbers on the keypad. The garage door should open or close in response to the code.
If the garage door does not respond to the new code, repeat the process from step 1 to step 4, making sure that you follow the instructions carefully. If you are still unable to reset your Clicker garage door keypad, you may need to consult the user manual for your specific garage door opener or contact a professional garage door technician for assistance.
In conclusion, resetting your Clicker garage door keypad can be a simple process that can be accomplished in a few easy steps. By following the steps outlined above, you can ensure that your Clicker garage door keypad is functioning properly and providing a secure way to enter and exit your garage.
Wise County Door and Gate
1-940-304-0821