Resetting a Genie Garage Door Repair opener can be necessary for a variety of reasons, including if the door is not responding to the remote control or if you want to change the code for security reasons.
The process of resetting a Genie Garage Door Repair opener involves clearing the memory and reprogramming it with new codes. Below are the steps to reset a Genie garage door opener:
Step 1: Locate the Learn Code button The Learn Code button is located on the powerhead of the Genie garage door opener. It is usually a square or circular button with the word “Learn” or “Set” printed on it. If you’re having trouble finding it, consult your Genie garage door opener manual.
Step 2: Press and hold the Learn Code button Press and hold the Learn Code button for about 10 seconds until the LED light next to the button turns off. This will clear all the codes that have been programmed into the Genie garage door opener’s memory.
Step 3: Choose a new PIN Choose a new PIN for your Genie garage door opener. The PIN is a four-digit code that you will use to operate the door. Make sure that the new PIN is something that you will remember, but is not too easy for someone else to guess.
Step 4: Press the Learn Code button again Press the Learn Code button again, and hold it until the LED light comes back on. This will put the Genie garage door opener into programming mode.
Step 5: Enter your new PIN Enter your new PIN on the remote control that you want to use to operate the door. Make sure that you press the buttons firmly and that you enter the correct sequence.
Step 6: Test the new code Test the new code by pressing the button on the remote control. The door should open or close, depending on the button that you pressed. If the door does not respond, repeat the process from step 2.
Step 7: Reprogram other remotes If you have other remotes that you want to use to operate the door, you will need to program them using the same process as above. Make sure that you use the same new PIN for all the remotes.
Step 8: Finish programming Once you have programmed all the remotes with the new PIN, press the Learn Code button on the Genie garage door opener one more time to exit programming mode.
In summary, resetting a Genie garage door opener involves clearing the memory and reprogramming it with a new PIN code. By following the steps outlined above, you can reset your Genie garage door opener and make it more secure. If you encounter any issues during the process, consult your Genie garage door opener manual or contact a professional for assistance.
Dragon Garage Door & Gates
351 Central Ave #7, Southlake, TX 76092, United States
1-817-587-0445