Resetting your Raynor Arlington Garage Door Repair is a straightforward process that can be accomplished with a series of carefully executed steps.
Below, you’ll find a comprehensive guide to resetting your Raynor garage door keypad, ensuring a smooth and successful reset.
1. Locate the Keypad: Begin by identifying the location of your Raynor garage door keypad. Typically, it is situated outside the garage, near the entrance. Look for a small device with a numerical keypad and possibly a cover.
2. Remove the Keypad Cover: To access the internal components of the keypad, you’ll need to remove the cover. This is usually achieved by sliding the cover up or, in some cases, by gently prying it open with a screwdriver. Exercise caution to avoid damaging the cover.
3. Find the Program Button: Inside the keypad, you’ll discover a small, round button labeled “Prog” or “Program.” This button is crucial for initiating the reset process.
4. Press and Hold the Program Button: Press and hold down the program button. Continue holding it until you observe the LED light on the keypad blinking. The blinking light indicates that the keypad has entered programming mode.
5. Enter the Reset Code: Refer to your user manual for the specific reset code required for your Raynor keypad. Enter this code using the numerical buttons on the keypad. The keypad may emit a beep to confirm each digit entry.
6. Release the Program Button: After entering the reset code, release the program button. The LED light should stop blinking, signaling the completion of the reset process.
7. Test the Keypad: Close the keypad cover securely and test the keypad by entering your garage door access code. Verify that the garage door responds appropriately to the input.
8. Reset Additional Features (Optional): Certain Raynor keypads come equipped with extra features, such as the ability to control multiple garage doors. If applicable, consult your user manual to reset these features according to your preferences.
9. Replace the Keypad Cover: Once the reset is confirmed, close and latch the keypad cover securely. This step is essential to protect the internal components from weather elements and potential damage.
10. Verify Garage Door Operation: Ensure that the garage door operates as expected using the keypad. If any issues arise during this test, consult the troubleshooting section of your user manual or consider reaching out to Raynor customer support for further assistance.
Always remember that these instructions provide general guidance and that specific steps may vary based on the model of your Raynor Arlington Garage Door Repair. For precise and model-specific information, refer to the user manual supplied by Raynor. In case of difficulties, don’t hesitate to contact Raynor’s customer support for expert assistance.
Arlington Overhead & Garage Doors
817-646-2532