Resetting the Garage Door Repair Bedford TX is a relatively straightforward process that involves a series of steps to clear existing programming and reprogram the HomeLink system.

Follow these detailed instructions to reset the garage door opener on your Toyota Highlander:

  1. Prepare for Reset: Ensure that your Toyota Highlander is parked in a safe and accessible location. Make sure you have the remote control for your garage door opener and the owner’s manual for your Highlander.
  2. Locate HomeLink Buttons: Find the HomeLink buttons in your Highlander. These buttons are typically located on the rearview mirror or the overhead console. There are three HomeLink buttons that you can program for different garage doors.
  3. Clear Existing Programming: Press and hold the first and third HomeLink buttons simultaneously. Hold them for about 20 seconds until the indicator light on the HomeLink buttons starts flashing rapidly. This action clears any existing programming.
  4. Choose a Button for Programming: Decide which HomeLink button you want to program for your garage door opener. You can choose any of the three buttons based on your preference.
  5. Hold Remote and HomeLink Close: Take the remote control for your garage door opener and hold it about 1-3 inches away from the HomeLink buttons in your Highlander.
  6. Simultaneously Press Remote and HomeLink Buttons: While holding the remote close to the HomeLink buttons, press the button on the remote and the chosen HomeLink button simultaneously. Hold both buttons down until the HomeLink indicator light starts flashing slowly.
  7. Training Mode: After a few seconds, the indicator light on the HomeLink buttons will change from a slow flash to a rapid flash. This indicates that the HomeLink system is in training mode and ready to learn the garage door opener’s signal.
  8. Program the Garage Door Opener: Locate the “Learn” or “Train” button on your garage door opener motor. Press this button. You typically have around 30 seconds to return to your Highlander and complete the programming.
  9. Test the HomeLink System: Press the programmed HomeLink button in your Highlander and observe if your garage door responds. If the programming is successful, the garage door should start moving.
  10. Repeat if Necessary: If the garage door doesn’t respond, repeat the process. It may take a couple of tries to ensure successful programming.
  11. Finalize Programming: Once the garage door responds to the HomeLink button, press and hold the button for a few seconds until the indicator light turns solid. This final step completes the programming process.
  12. Refer to Owner’s Manual: Consult your Highlander’s owner’s manual for any specific instructions or variations that may apply to your model. The manual may provide additional guidance or troubleshooting tips.

By following these detailed steps, you can successfully reset and program the Garage Door Repair Bedford TX, providing you with convenient access to your garage.

Bedford Gates & Garage Doors

817-886-3064